How to build a snake fence yourself
A weekend project for a small area, if you get the mesh, the bottom and the gates right.
Short answer: Fasten 1/4-inch galvanized hardware cloth along the fence line, bury the bottom 4 to 6 inches, lean the top slightly outward, and seal every gate and drain to 1/4 inch. Clear plants off the line. Most DIY failures happen at gates.
Key facts
Materials
- 1/4-inch galvanized or vinyl-coated hardware cloth, 36 inches wide (measure your feet and add 10%)
- Screws with washers, or heavy fence clips
- Stakes or T-posts for open ground
- Gate sweep or extra mesh for each gate; drain covers in 1/4-inch mesh
- Shovel or trencher, tin snips, gloves
Steps
- Measure the line and count gates and drains.
- Clear a strip of plants and debris along it.
- Trench 4 to 6 inches deep along the base.
- Hang the mesh with the bottom in the trench and the top leaning out.
- Backfill and tamp.
- Seal gates and drains to 1/4 inch.
- Inspect the whole line, especially corners and gates.
Mistakes that let snakes in
- Using 1/2-inch mesh
- Zip ties that break in the sun
- A gap under the gate
- Plants growing through or over the mesh
- A drain left open
Not sure you want to dig 200 feet of trench? Compare DIY and hiring a pro or get a free quote.
Sources
Get a free snake fence quote
Tell us about your property. We send it to one verified local installer, never a list. Free, no obligation.
✓ 1 verified installer, not 5 · ✓ Free · ✓ No obligation
Common questions
How deep should a snake fence be buried?
About 4 to 6 inches, or sealed to a concrete footing.
Can I attach snake mesh to a wood fence?
Yes. Fasten it along the base, bury the bottom edge, and seal gaps between boards near the ground.